MADShop: 336-751-7655
Tricia@MADceramics.com

Contact Mad Ceramics

Physical Address of Shop
118 Saytoe Street,
Mocksville, NC 27028

Mailing Address (only)
547 John Crotts Road
Mocksville, NC 27028

Directions


View Larger Map

The Shop is located off of Milling Road, on Saytoe Street, physical address of the Shop, NOT the mailing address, see above.

From Winston Salem on I-40, get off at the Farmington Road exit #174, go left & cross over 40. At the end turn right on 158 headed into Mocksville. There will be (2) 45MPH signs then (2) 35MPH signs, the second 35MPH sign is almost directly across from Milling Road. You will make a left on Milling Rd. and go approximately 3/4 mile. Our building is BEHIND Tri-Power. You will be going into their driveway. We have a big white barrel at the end of the driveway with our logo painted on it. (If you pass the Northwood Apts. on the left you went past the driveway!)

From Salisbury take 601 until you get to the light in town where 601 turns left (DON'T TURN) go straight ahead through the center of town Main Street turns into 158. You will pass the Brock Center and further down the road you will come to a yellow house with a white picket fence. Make a right onto Milling Road and go approximately 3/4 mile. Our building is BEHIND Tri-Power.

From Lexington take 64 to John Crotts Road (you can only turn left onto John Crotts Rd, it will be the FIRST left after the Crossroads Grocery/Gas Station). Follow it around to Bethal Church Road and turn right. (If you pass Bethal Church Road you will end up back on 64). Take Bethal church Road to the end and turn left on Milling Road. Go about 1/4 mile and turn left after you pass Tri Power's building. Our building is BEHIND Tri-Power. You will be going into their driveway.

From Statesville take I-40 East to exit 170. Turn right at the end of the exit ramp. Turn Left at the Kentucky Fried Chicken (Country Lane). After a sharp bend in the road turn right on Campbell Rd. (Approximately 1 1/2 miles). Take Campbell Rd. to the end. Turn left on to Main Street then IMMEDIATELY right onto Milling Road. The Shop will be about 3/4 mile on the right. Our building is BEHIND Tri-Power. You will be going into their driveway.

Hours

Shop Open Workshop Hours:
Mon, Tues & Fri mornings 10:00am-1:00pm
Mon, Wed & Fri evenings 6:00pm-8:00pm

The shop is closed on all Federal Holidays or when I am attending a show (check the Shows/Seminars page or call).

Ellis Park Ceramic Class Hours:
Wednesday mornings 9:00 am-12:00 pm.


View Larger Map

PLEASE NOTE: if the weather is bad during the winter and the local schools are closed, the Shop and Ellis Park Classes will be Closed too.